®Extender for HDMI® 1.3 over CAT5 with EthernetEXT-HDMI1.3-CAT5-ELRUser Manual
7RECEIVER UNIT DESCRIPTIONS1 IR SensorReceives signals from the Hi-Def source IR remote control. The IR signals are sent back to the source device, w
81. Connect the Hi-Def source to the Sender Unit using the included HDMI cable.2. Use an HDMI cable to connect the HDTV display to the Receiver Unit
9DIP SWITCHESDIP Switch LocationOn the bottom of the Extender for HDMI 1.3 with Ethernet Receiver unit there are four (4) DIP switches.The DIP switche
10DIP SWITCH SETTINGSDIP 1 - EDID ModeON (default) - External EDID Mode• DDC and HPD are passed through. Both the connection status and the full A/V
11NETWORK CABLE WIRING DIAGRAM12345678Gefen recommends the TIA/EIA-568-B wiring option. Please adhere to the table below when fi eld terminating cable
12MOUNTING PLATE INSTALLATION123Remove the rubberfeet covering the screwsoff the bottom of theunit.Remove the screws.Line up the mountingplates and sc
TERMINOLOGYCAT-5/CAT5eCategory 5 cable, commonly known as Cat 5, is an unshielded twisted pair type cable designed for high signal integrity. The actu
12Video Amplifi er Bandwidth ... 225 MHz Input Video Signal ...
Rev A1029.6Pb20600 Nordhoff St., Chatsworth CA 913111-800-545-6900 818-772-9100 fax: 818-772-9120www.gefen.com [email protected]
ASKING FOR ASSISTANCERev A1029.6Technical Support:Telephone (818) 772-9100 (800) 545-6900Fax (818) 772-9120Technical Support Hours:8:00 AM to 5:
CONTENTS1 Introduction2 Operation Notes3 Features4 Sender Unit Layout5 Sender Panel Descriptions6 Receiver Panel Layout7 Receiver Panel Descriptio
1Congratulations on your purchase of the Extender for HDMI 1.3 over CAT5 with Ethernet. Your complete satisfaction is very important to us.GefenGefen
READ THESE NOTES BEFORE INSTALLING OROPERATING THE EXTENDER FOR HDMI 1.3 OVER CAT5 WITH ETHERNET• The Extender for HDMI 1.3 over CAT5 with Ethernet u
3HDMI 1.3 Features• 225 MHz (up to 12-bit YUV 444 @ 1080p)• Deep Color• Dolby TrueHD and DTS-HD Master Audio• Lip-Sync• CEC Pass-ThroughFeatures• E
4SENDER UNIT LAYOUTBackFront123456
5SENDER UNIT DESCRIPTIONS1 5V DC Locking Power ConnectorConnect the included 5V DC locking power supply to this connector. Only use the power supply
6RECEIVER UNIT LAYOUTFrontBack1234567
Commentaires sur ces manuels