wwwwwwwwwwwwwwwwwwwwwww.gefen.comEXT-HDMI1.3-1FOUser Manual
6RECEIVER UNIT LAYOUTFront Back17426358
7RECEIVER UNIT DESCRIPTIONS1RS-232 Output PortConnect a controlling device to this port.2 Locking HDMI Output PortConnect a HDTV display to this HDMI
8EXT-HDMI1.3-1FOSC-SC FIBER OPTIC CABLE (Up to 1,000 ft)SenderRS-232 ControllerHi-Def SourceReceiverHD Displaywith RS-232 ControlHDMI CABLERS-232IRIR
DIP SWITCH CONFIGURATION9DIP SwitchesOn the bottom of the Sender Unit and Receiver Unit are a bank of four (4) DIP switches. These DIP switches provi
10DIP SWITCH CONFIGURATIONDIP 1 - EDID Mode•OFF - Local EDIDWhen Local EDID mode is used, the EDID will be assembled by copyingall video and audio fea
11DIP SWITCH CONFIGURATIONCalibrating the Sender Unit and Receiver UnitIMPORTANT: Before beginning the calibration process, make sure that theSender U
12SPECIFICATIONSVideo Amplifi er Bandwidth ... 225 MHzMaximum Resolutions Supporte
WARRANTY13Gefen warrants the equipment it manufactures to be free from defects in material and workmanship.If equipment fails because of such defects
20600 Nordhoff St., Chatsworth CA 913111-800-545-6900 818-772-9100 fax: 818-772-9120www.gefen.com [email protected] A6This product uses UL
ASKING FOR ASSISTANCETechnical Support:Telephone (818) 772-9100 (800) 545-6900Fax (818) 772-9120Technical Support Hours:8:00 AM to 5:00 PM Monda
CONTENTS1 Introduction2 Operation Notes3 Features4 Sender Unit Layout5 Sender Unit Descriptions6 Receiver Unit Layout7 Receiver Unit Descriptions
1INTRODUCTIONCongratulations on your purchase of the Extender for HDMI 1.3 Over One Fiber with IR. Your complete satisfaction is very important to us.
2OPERATION NOTESREAD THESE NOTES BEFORE INSTALLING OROPERATING THE EXTENDER FOR HDMI 1.3 OVER ONE FIBER WITH IR• IR data repeater functionality is sin
3FEATURESHDMI 1.3 Features• 225 MHz (up to 12 bit YUV 444 @ 1080p)• Deep Color• Dolby TrueHD and DTS-HD Master Audio• Lip-Sync• CEC Protocol Pass-Thro
4SENDER UNIT LAYOUTFrontBack5463721
5SENDER UNIT DESCRIPTIONS1Power IndicatorThis two-color LED will turn bright red once the included 5V DC locking power supply has been properly connec
Commentaires sur ces manuels