Gefen EXT-DVI-CAT5-4X Manuel d'utilisateur télécharger pdf (Page 9)

How to Connect the DVI CAT5 4X Extender

1. Connect your sources (up to four) to the DVI CAT5 4X Extender unit’s DVI

inputs using the supplied DVI cables.

2. Connect your displays (up to four) to the DVI CAT5 MSR receiver unit’s

DVI outputs using user supplied DVI cables.

3. Connect both CAT-5, CAT-5e or CAT-6 cables (DDC and Video) between

the DVI CAT5 4X Extender and each DVI CAT5 MSR receiver.

NOTE: If ﬁ eld terminating network cable, please adhere to the TIA/EIA-568-B

standard. Please see page 9 for more information.

4. Connect the 24V DC power supply into the DVI CAT5 4X Extender sender.

5. Connect the 5V DC power supplies into each of the DVI CAT5 4X receivers.

6. Power on the displays.

7. Power on the sources.

NOTE: If an image is not being shown on the display, please check all cabling for

proper connections and follow the steps outlined below and in the next section.

DVI CAT5 4X EXTENDER CONFIGURATION

The DVI CAT5 4X Extender and DVI CAT5 MSR receivers have built-in auto

equalization that will automatically tune out any unwanted video noise. This

feature is reliable with premium cable runs up to a maximum of 130 feet. It may

be necessary to disable this feature if there is either no video being displayed on

initial start-up, there is video noise in the image, or the cable run exceeds 130

feet. First, verify that all the proper connections have been made and that all

devices are powered on before attempting to disable auto equalization. Please

follow the section on the next page to manually equalize the video signal.

CONNECTING AND OPERATING THE DVI CAT5 4X EXTENDER

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Pas de commentaire

Gefen EXT-DVI-CAT5-4X Manuel d'utilisateur Page 9