Gefen EXT-HDKVM-LANTX Manuel d'utilisateur télécharger pdf (Page 16)

Page Title

Getting Started

The HD KVM over IP Sender and Receiver units can either be connected over a Local Area

Network (LAN) or they can be directly connected to one another.

Using a Direct Connection

By default, the HD KVM over IP is shipped in Auto IP mode. In Auto IP mode, each

Sender and Receiver unit assigns itself a unique IP address within the range of

169.254.x.x. Auto IP mode is only used when Sender and Receiver units are directly

connected to one another. When connecting to a network, the HD KVM over IP must be

set to DHCP mode or Static IP mode. See Setting the IP Mode for more information.

1. Connect a CAT-5e (or better) cable from the LAN port on the Sender unit to the

LAN 1 port on the Receiver unit.

Figure 1.1 - Directly connecting the Sender and Receiver unit

Although any LAN port on the Receiver unit can be used, using the LAN 1 port makes

it easy to identify which Ethernet cable is used to connect the Sender and Receiver

unit. LAN 2 and LAN 3 ports can then be used for connecting additional devices or

when daisy-chaining Receiver units.

2. Use the included HDMI cable to connect the Hi-Def source to the HDMI In port on the

Sender unit.

3. Connect a HDMI cable from the Hi-Def display to the HDMI Out port on the Receiver

unit.

page | 6

Installation

Connect to other

Receivers / IP devices

Sender unit

CAT-5e cable (or better)

Receiver unit

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 36 37

Pas de commentaire

Gefen EXT-HDKVM-LANTX Manuel d'utilisateur Page 16