17
ROUBLESHOOTIN
able recommendation
olid core
AT-
e cable rated at
MHz and terminated in
a or
b is th
inimum requirement. For resolutions
reater than 1280x1024 or 1080i,
e
e
ecommends solid shielded
AT-
cables.
o vide
ake sure that DIP switch 2 on the
ender Unit is set to the
FF position. Also
ake sure that DIP switch 7 on the Receiver Unit is set to the
FF position. I
ither o
these DIP switches are in the
N position
Field-Upgrade Mode,
a
e 10 and 13
then the
ender Unit or Receiver Unit will not
unction as an
xtender. Next, make sure that the
AT-5 cable, connectin
the
ender Unit and
eceiver Unit is connected to the LINK port. I
this does not solve the issue, tr
disconnectin
and then reconnectin
the A
power cord
rom the
ender Unit.
Also, veri
that both units are workin
with short
AT-5e cables
15 - 20
eet
.
ntermittent loss of vide
Flickerin
or a blinkin
ima
e is the result o
a loss o
s
nc between the displa
and the source. Tr
lowerin
the source resolution
e.
.
rom 1080p to 720p
. I
this solves the issue, then the
AT-5 cables bein
used to connect the
ender
nit and the Receiver Unit are unable to handle the bandwidth o
the hi
her
esolution and thus
ou are losin
s
nc. Replace the existin
AT-5 cables with
a shielded
AT-6 cable. Electroma
netic Inter
erence
EMI
rom
uorescent
i
hts,
enerators, and A
unit motors can also cause intermittent loss o
video.
hielded
AT-
cable with the drain wire soldered to the connectors will resolve
the issue. Also make sure to eliminate an
patch panels and wall plates. Patch
anels and wall plates are prone to EMI i
the
are not shielded properl
mage is tinted green or pin
An ima
e that is tinted
reen or pink is the result o
the incorrect color space
bein
transmitted. Make sure that the displa
and source both support the same
olor space.
ettin
DIP switch 1 on the Receiver Unit, to the
FF position, will
se the Local EDID. EDID
eatures newer than HDMI 1.
are removed when
the displa
is read. This provides a
eneral EDID which is compatible with more
displa
s.
Commentaires sur ces manuels